TSOP572.., TSOP574..
www.vishay.com
SUITABLE DATA FORMAT
The TSOP572.., TSOP574.. series is designed to suppress
spurious output pulses due to noise or disturbance signals.
The devices can distinguish data signals from noise due to
differences in frequency, burst length, and envelope duty
cycle. The data signal should be close to the device’s
band-pass center frequency (e.g. 38 kHz) and fulfill the
conditions in the table below.
When a data signal is applied to the TSOP572.., TSOP574..
in the presence of a disturbance, the sensitivity of the
receiver is automatically reduced by the AGC to insure that
no spurious pulses are present at the receiver’s output.
Vishay Semiconductors
Some examples which are suppressed are:
0
5
10
15
20
? DC light (e.g. from tungsten bulbs sunlight)
16920
Time (ms)
? Continuous signals at any frequency
? Strongly or weakly modulated patterns from fluorescent
lamps with electronic ballasts (see figure 12 or figure 13)
Fig. 13 - IR Signal from Fluorescent Lamp
with Low Modulation
0
5
10
15
20
16921
Time (ms)
Fig. 14 - IR Signal from Fluorescent Lamp
with High Modulation
TSOP572..
TSOP574..
Minimum burst length
After each burst of length
a minimum gap time is required of
For bursts greater than
a minimum gap time in the data stream is needed of
Maximum number of continuous short bursts/second
NEC code
RC5/RC6 code
Thomson 56 kHz code
Suppression of interference from fluorescent lamps
10 cycles/burst
10 to 70 cycles
≥ 10 cycles
70 cycles
> 4 x burst length
800
yes
yes
yes
Most common disturbance
patterns are suppressed
10 cycles/burst
10 to 42 cycles
≥ 10 cycles
42 cycles
> 10 x burst length
1300
preferred
preferred
preferred
Even extreme disturbance
patterns are suppressed
Notes
? For data formats with short bursts please see the datasheet for TSOP573..
? Best choice of AGC for some popular IR-codes:
TSOP57436: RC-5, RC-6, Panasonic;
TSOP57438: NEC, Sharp, r-step;
TSOP57456: r-step, Thomson RCA
Rev. 1.7, 25-Feb-14
5
Document Number: 82434
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000
相关PDF资料
TSOP6238TT IR RECEIVER 38KHZ 40M TSOP6238
TSTFT3.5I# TOUCH PANEL 140X1.4.0 TFT
TSTFT5.7I# TOUCH PANEL 132.5X104.7 TFT
TT8J21TR MOSFET P-CH 20V 2.5A TSST8
TT8J2TR MOSFET 2P-CH 30V 2.5A TSST8
TT8K2TR MOSFET 2N-CH 30V 2.5A TSST8
TT8M2TR MOSFET N/P-CH 30V 2.5A TSST8
TT8U1TR MOSFET P-CH 20V 2.4A TSST8
相关代理商/技术参数
TSOP57238TT2 制造商:Vishay Angstrohm 功能描述:IR Remote Receiver 38KHz 40m 8-Pin T/R 制造商:Vishay Semiconductors 功能描述:SMD PH.MODULE 38KHZ T.VIEW-E3 - Tape and Reel
TSOP57240TT1 功能描述:红外接收机 IR SENSOR IC 40KHZ, E3 RoHS:否 制造商:Vishay Semiconductors 载频:20 kHz to 60 kHz 传输距离:5 m 显示角:+/- 50 deg 高电平脉冲宽度: 低电平脉冲宽度: 最小高电平输出电压: 输出电流:5 mA 工作电压:2.5 V to 5.5 V 电源电流:0.9 mA 功率耗散: 最大工作温度:+ 85 C 最小工作温度:- 25 C 封装 / 箱体: 封装:Reel
TSOP57256TT1 功能描述:红外接收机 IR SENSOR IC 56KHZ, E3 RoHS:否 制造商:Vishay Semiconductors 载频:20 kHz to 60 kHz 传输距离:5 m 显示角:+/- 50 deg 高电平脉冲宽度: 低电平脉冲宽度: 最小高电平输出电压: 输出电流:5 mA 工作电压:2.5 V to 5.5 V 电源电流:0.9 mA 功率耗散: 最大工作温度:+ 85 C 最小工作温度:- 25 C 封装 / 箱体: 封装:Reel
TSOP57338TT1 功能描述:红外接收机 IR SENSOR IC 38KHZ AGC 3 RoHS:否 制造商:Vishay Semiconductors 载频:20 kHz to 60 kHz 传输距离:5 m 显示角:+/- 50 deg 高电平脉冲宽度: 低电平脉冲宽度: 最小高电平输出电压: 输出电流:5 mA 工作电压:2.5 V to 5.5 V 电源电流:0.9 mA 功率耗散: 最大工作温度:+ 85 C 最小工作温度:- 25 C 封装 / 箱体: 封装:Reel
TSOP57338TT2 制造商:Vishay Angstrohm 功能描述:IR Remote Receiver 38KHz 40m 8-Pin T/R 制造商:Vishay Semiconductors 功能描述:SMD PH.MODULE 38KHZ T.VIEW-E3 - Tape and Reel
TSOP57356HTT1 制造商:Vishay Semiconductors 功能描述:SMD IR RECEIVER 56KHZ TOP VIEW WITH SHIELD - Rail/Tube
TSOP57438TT1 功能描述:红外接收机 IR SENSOR IC 38KHZ AGC 4 RoHS:否 制造商:Vishay Semiconductors 载频:20 kHz to 60 kHz 传输距离:5 m 显示角:+/- 50 deg 高电平脉冲宽度: 低电平脉冲宽度: 最小高电平输出电压: 输出电流:5 mA 工作电压:2.5 V to 5.5 V 电源电流:0.9 mA 功率耗散: 最大工作温度:+ 85 C 最小工作温度:- 25 C 封装 / 箱体: 封装:Reel
TSOP57438TT2 制造商:Vishay Semiconductors 功能描述: 制造商:Vishay Semiconductors 功能描述:SMD PH.MODULE 38KHZ T.VIEW 制造商:Vishay Intertechnologies 功能描述:IR Receivers / SMD PH.MODULE 38KHZ T.VIEW-e3